Free preview · full pattern in the Vintage Crochet Edgings & Trims
Figure 29 Rose Medallion Lace (1916): vintage crochet pattern
Eight-petal roses worked on a wound thread ring are joined in a row by long chains, filleted along both sides, and finished with a chain heading at the top and a lower edge of long-treble fans covered in single crochet.
By the crochetpatterns.io editorial team · Updated · Editorial policy · pattern testing in progress

| Detail | Value |
|---|---|
| Skill level | Advanced |
| Yarn weight | Lace (#0) |
| Yardage | the book gives no thread quantity for any design. (as printed; yardage not given) |
| Hook | 1 mm |
| Gauge | No gauge printed. Work a sample repeat and match the hook to the thread. |
| Finished size | Not printed — the piece is worked to the length required. |
| Time | about 3 hours |
Materials
- Size 70 crochet thread — approximate modern equivalent of the book's No. 70 crochet cotton
- 1.0 mm steel hook (US steel 12) — approximate for the book's No. 12 hook
- Fine tapestry or sewing needle for the ends
- Hook: Start with 1.0 mm (US steel 12) — approximate for the book's No. 12 hook; change size until the thread runs easily without splitting and the lace lies flat.
Yarn Kit & Substitution Options
This pattern calls for 350 yards of weight #0 yarn. Select a suggested yarn to see required skeins and estimated cost:
Caron Simply Soft · 100% Acrylic
315 yds per skein · High-yield yardage, silky no-scratch texture
2 skeins required
approx. $$10.98 total
Abbreviations (US terms)
- chain
- single crochet
- double crochet
- treble crochet
- double treble crochet
- slip stitch
- stitch
- stitches
- skip
- space
- repeat
- row
- round
- loop
Notes before you start
- Source: "Figure 29. Rose Medallion Lace", The Priscilla Crochet Book: Edgings and Insertions, No. 2 (Edited by Belle Robinson), The Priscilla Publishing Company, Boston, 1916. Public domain in the USA.
- As printed — materials: Crochet cotton No. 70 — the book's Materials paragraph says “crochet cotton” means the hard-twisted cotton sold as Cordonnet, Cordonnet Special, Cordichet, Kord-net and similar; Hook No. 12. Gauge: Not given.
- Modernisation note: Stitches converted by the book's own “Explanation of Stitches” (printed page 3), not by name. This book uses the older British-style naming, so its stitch names do NOT match modern US names: chain (ch) = ch; slip stitch (sl) = sl st; “double” (d), “put hook through work, draw thread through work (making two loops on the hook); thread over again and through both loops” = modern US single crochet (sc) — the book itself notes this stitch “has been, especially in wool crochet, called ‘single crochet’”; “half treble” (ht), thread over, through work, “thread over and through all three sts at once” = modern US half double crochet (hdc); “treble” (t), thread over, through work, “thread over and through two loops, thread over and again through two loops” = modern US double crochet (dc); “double treble” (dt), thread over twice and worked off by twos three times = modern US treble crochet (tr); “long treble” (lt) or “triple treble” (tt), thread over three times and crocheted off by twos = modern US double treble (dtr); “quadruple treble” (qt), thread over four times = modern US triple treble (trtr). Every stitch in these instructions has been rewritten in the modern US name and abbreviation on that basis.
- Modernisation note: The book's abbreviations are written in modern US form: d = sc, ht = hdc, t = dc, dt = tr, lt/tt = dtr, st(s) = st(s), sp = sp, p = picot, blk = block, “miss” = sk, “thread over (the hook)” = yo, “repeat” = rep, “needle” (where it is used for the crochet hook) = hook. Ordinal row names (“1st row”, “2d row”) are written Row 1, Row 2, and “1st round”/“2d round” as Rnd 1, Rnd 2. Section headings (Heading, Edge, Lower Edge, Filling) are the book's own where it prints them.
- Modernisation note: The book prints each design as one or two solid paragraphs; these have been split into one row, round or step per line. Stitch order and counts are unchanged. Where the book's own repeat markers (*, **, ***) span several lines they are kept as printed.
- Modernisation note: Thread sizes are the book's own numbering. Its Materials paragraph says that “where the words ‘crochet cotton’ are used in the text of this book, the cotton referred to is the hard-twisted cotton known by such names as Cordonnet, Cordonnet Special, Cordichet, Kord-net, etc.” “No. N crochet cotton” is given below as modern size N crochet thread, which is an approximation: modern size numbering runs the same way (higher number = finer thread) but the exact diameters are not identical. No yardage is printed anywhere in the book, so none is given here.
- Modernisation note: Hook sizes are the book's own steel numbering. The 1916 steel numbering is not identical to the modern one, so every metric size below is approximate and should be adjusted to the thread.
- Modernisation note: No gauge and no finished measurements are printed for this design; work a sample repeat and adjust the hook until the lace lies flat at the width you want.
- Modernisation note: Metric conversions added.
- Modernisation note: The book warns that “sometimes ‘long treble’ is used for anything longer than dt, and the number of loops given”. Wherever it writes “long t (over N times)” the wrap count is kept in the modern text, because the height of that stitch is set by the wrap count and not by the name: over 3 times = dtr, over 4 times = trtr, and longer wraps are written out as they are printed.
Row progress: 0 of 6 done (0%)
Rose
0 of 6 done- Wind the working thread 20 times around the top of the crochet hook, slip it off and work 16 sc in the ring, sl st in the 1st sc to join.Mark row complete
- Ch 8, sk 1, 1 dc in the next st, (ch 5, sk 1, 1 dc in the next st) 6 times, ch 5, sl st in the 3rd of the first ch-8.Mark row complete
- * 7 sc on the ch-5, ch 6, 1 sc in the top of the last sc; rep from * around, making 8 loops in all, sl st to the fourth of the 7 sc.Mark row complete
- ** 11 dc in the ch-6 loop, sl st in the 4th of the next 7 sc; rep from ** around.Mark row complete
- Sl st to the 6th of the 11 dc, ch 14, 1 dc in the centre of the next petal, ch 9, 1 tr in the centre of the next petal, ch 9, 1 tr in the same place with the last tr, ch 9, 1 dc in the centre of the next petal, ch 9, 1 sc in the centre of the next petal, ch 9, 1 tr in the same place with the last tr, ch 9, 1 sc in the next petal, ch 9, 1 tr in the next petal, ch 9, 1 tr in the same place with the last tr, ch 9, 1 dc in the next petal, ch 9, 1 tr in the centre of the next petal, ch 9, sl st in the 5th of the first ch-14, fasten off.Mark row complete
- In working the second and following flowers they must be joined to the 5th of the 9 ch between the tr of the preceding one with a sl st, after working 4 of the 9 ch between 2 tr.Mark row complete
Working on:
Wind the working thread 20 times around the top of the crochet hook, slip it off and work 16 sc in the ring, sl st in the 1st sc to join.
Continue this pattern
The rest of the Figure 29 Rose Medallion Lace (1916) pattern is in the Vintage Crochet Edgings & Trims
Still to come in the full pattern:
- Filet along the strip
- Heading
- Lower Edge
- Finishing
Included with 618 patterns for $9 — $0.01 per pattern.

Errata
No corrections have been published for this pattern. Found a mistake? Tell us and we will log the fix here with a date.
Your notes on this pattern
Keep track of the yarn, hook and changes you used. Saved in this browser only — nobody else can see it.
Frequently asked questions
Where is the Figure 29. Rose Medallion Lace pattern from?
It was published as "Figure 29. Rose Medallion Lace" in The Priscilla Crochet Book: Edgings and Insertions, No. 2 (Edited by Belle Robinson) by The Priscilla Publishing Company, Boston in 1916. The publication is in the public domain in the United States; this version is transcribed and modernised by crochetpatterns.io.
What yarn or thread do I need for the Figure 29. Rose Medallion Lace?
Size 70 crochet thread. Not printed — the book gives no thread quantity for any design.
What hook should I use?
Start with 1.0 mm (US steel 12) — approximate for the book's No. 12 hook; change size until the thread runs easily without splitting and the lace lies flat. Gauge: No gauge printed. Work a sample repeat and match the hook to the thread.







